6 CHANNEL VOICE DIALER WITH INTERROGATION

The Dialguard DT6I uses client programmable voice messages to report an alarm condition to any telephone anywhere in the world.

The Nidac dialer is suitable for a wide variety of equipment including, alarm panels, medical dailing systems and industrial equipment.

All programming, including the recording of user voice messages, can be done on site via the onboard keypad and microphone. Programmed information can be replayed on the display for confirmation; the display will also indicate anyerrors made during programming. Voice messages can be replayed through the built in speaker.

The user voice memory can store up to 5 user alarm messages and an address/name message which is playedover the phone during an alarm report. The DT6I has pre-recorded messages for fire, burglary, duress, power fail, medical alarm, test and inactivity. A battery low condition will automatically be reported if enabled and aninput set up for power failure can be programmed to reportthe condition if the power is off for between 1 & 90 minutes.

With the addition of a Nidac DRI or DRI-24 Dialler relay Interface you can dial into the DT6I and trigger up to two outputs. This is a useful home automation function that can be used to remotely activate a device such as hydronic heating for example.

FEATURES:

• external alarm inputs, each with user recordable message
• User recordable name & address message
• Programmable delay of up to 99 minutes for power failure reporting
• Internal battery low alarm with optional reporting
• Non-volatile memory stores programmed data and voicemessages for 10 years without power
• 6 user programmable phone numbers
• 9 user programmable phone number groups
• Two relay control outputs with the addition of a Nidac DRI or DRI-24 Dialler Relay Interface give home automation functionality
• 12 Volt D.C. operation standard, or 24 Volt D.C. operation with the addition of a Nidac DRI-24 Dialler Relay Interface
• Ability to ring into the dialler to change phone numbers, phone number groups and read the diallers status
• Up to 6 dialing attempts at communicating an alarm condition
• Remote shutdown of the dialler via user programmableshutdown code of between 1 and 7 digits in length on DTMF telephones
• Fully programmable via the on board keypad
• Programmed information can be verified by replaying it on the 7 segment display (numeric data) or through the on board speaker (voice data)
• Programmable polarity on all inputs
• Programmable selection of ‘24 Hour’ or ‘Away/On’ mode on individual alarm inputs
• Dialler key switch input to select between ‘24 Hour’ or ‘Away/On’ modes
• 3 year warranty
• A-Tick approved