2CH CLASS D PA AMPLIFIER

The D-300.2 switching power professional Amplifier is designed for professional use on stage.
The high-quality components and the carefully designed circuits ensure excellent audio performance and an extremely linear frequency response.
The switching technology offers a bettercontrol of heat dissipation than conventional power supply systems.
A drastic reduction of dimensions and weight, for easier transportation and installation.
This Amplifier guarantees total reliability and a trouble-free use even in the most demanding conditions.
Thismodel will provide a perfect performance, what you get is unprecedented performance at an incredibly attractive price.

(D300.2)

12 Months

High current switching power allowing high power output with low noise and low distortion
Substantial protection circuitry such as thermal, short circuit, power on/off muting
Built-in limiter
Balanced XLR-TRS combo input jack
Front mounted gain controls for easy access
Signal, Clip protect and Power LED indicators to monitorstatus
Low impedance load(2Ω, 4Ω, 8Ω) output
Banlanced XLR input, 1/4"(6.3mm) TRS, and output barrierstrip 2-speakon
Stereo(dual-channel) or bridged mono operating modes

Power Specifications (tolerance +/-5%)				D-150.2
Stereo Mode (Both Channels Drive)	2 Ohms (RMS)			600W*2
	4 Ohms (RMS)			300W*2
	8 Ohms (RMS)			180W*2
Bridge Mono Mode	4 Ohms (RMS)			1200W
	8 Ohms (RMS)			600W
Electrical Specification
Input Sensitivity(limit OFF)			0.9-1.1V (0±1dBv)
Input Impedance			20KO balanced or 10KO Unbalanced
Frequency Response (At 10dB Below Rated Output Power)			20 Hz~20 KHz (0±1 dB)
Voltage Gain			30±0.5dB
THD+N(Ref.1K 1/8 Rated Power, A-Weighted)			<0.05%
S/N rate(Ref. Rated Power, A-Weighted)			>98 dB
Crosstalk(Below Rated Power)			>70 dB
Damping factor(1K 8O)			>180
Power/Output Circuitry			Switching Power-CLASS D
General Specifications
Protections		Full short circuit, open circuit, thermal, ultrasonic and RF protection stable into reactive or mismatched loads, turn ON/OFF, muting, tried crowbar.
Controls		Front: AC switch, Input level control for each channel Rear: stereo/ bridged/ parallel selector, limit ON /OFF selector
Indicators		SIGNAL: 2 green LED CLIP : 2 red LED POWER: 1 blue LED PROTECTION: 2 red LED
Connectors		INPUT : Active balanced XLR or TRS JACK OUTPUT: TRS JACK and speak-on jacks
Power Supply		220-240V AC 50/60 Hz ± 10%
Dimensions(W x D x H)		483 x 281 x 44 mm (19" x 11" x 17.3" )
Weight(Approximately)		3.7KG (8.1lb)